WAVLINK AC1200 High Power Outdoor Weatherproof WiFi Range Extender/Wireless Access Point/mesh agent with Passive POE, Dual Band 2.4GHz 300Mbps+5.8 GHz 867Mbps, 4x7dBi Detachable Omni Directional Antennas, Mesh Technology Supported, No WiFi Dead Zones for Working from Home

Greenwood-5-1200G

Model: WL-WN572HP3-GW

[AC 1200 Dual-Band & Upgraded Chip & Easy Mesh Technology Supported]: The next generation of Wi-Fi, complies with IEEE 802 11 ac/a/b/g/n standards. Dual-Band maximum speed up to 5GHz 867Mbps and 2.4GHz 300Mbps, an upgraded version of AC1200(1200Mbps); With a brand-new chip MT7621A and Easy Mesh supported, it lets you keep more devices(64~96) connected simultaneously with the dual bands and enables Wavlink mesh router/AP/repeater to work together, which is superior choice for seamless HD streaming, online gaming and other bandwidth-intensive tasks.

[Multiple Operation Modes & Power Over Ethernet & Dual Gigabit Ethernet Ports]: WL-WN572HP3 supports Mesh Extender Mode, Access Point (AP) Mode, and Repeater Mode. Integrated Power over Ethernet (PoE) supported, allowing it to be installed in areas where power outlet is not available by combing your power and network data connection into a single RJ-45 cable; Dual Gigabit (1000Mbps) LAN/WAN Ethernet Ports---support 10/100/1000Mbps speeds, 10x faster than a standard Ethernet port, giving you an excellent network speed experience.

[Design for Harsh Outdoor Environment & Strengthening Waterproof Version]: IP65-rated weatherproof & heat-resistant case that ensures continued operation on harsh outdoor environments or in climates of extreme cold, heat or continuous moisture, withstanding broad ranges of humidity and temperature (-30°C~70°C) (-22°F~158°F); 15KV ESD, 4KV lightning protection, ensure stable connection in harsh outdoor conditions. The key parts have been coated with waterproof glue to strictly avoid leakage phenomenon of the product. Note: The PoE part of the router is not waterproof.

[4 x 7dBi Detachable Omni Directional Antennas & Outstanding Function]: Higher antenna gain extensively strengthens Wi-Fi signal and expands wider coverage in the open air, stability technology automatically avoids channel conflicts using its channel selection feature, meet outdoor long range coverage wireless network requirement, cover hard-to-reach dead zones. High Power Amplifiers PA 800mW and enhanced receiver design for more strong penetration & longer range coverage than the general access point, ideal for providing Wi-Fi service in big area such as factory, community, street or etc.

[What You Get]: All Wavlink products come with a high-quality after-sale service. Please feel free to contact us anytime if you have any question, we will do our best to help you. In the Box: AC 1200 Dual Band Outdoor Ap/Range Extender, 2x 2.4 G Omni Antennas, 2x 5G Omni Antennas, 1x RJ 45 Networking Cable, 1x Power Adapter, 1x PoE Converter, 1x Main Body Holder, 2x Cable Ties, 1x Screw Fitting Kit, 1x Quick Start Guide. 12-month worry free warranty( extra 6 months for registered members) and life-long technical support.

Like it, Buy now:

Amazon US(JY)

Overview
Q&A

Q&A

What should I do if I could not log in the management page?

1.Please connect the wifi signal of wavlink device then use http://waplogin.link or http://192.168.30.1 to log in the management page.

2.Try to use different device like your phone or pc to log in the management page.

3.If you try to use your phone to log in the management page,please try to disable the mobile network.

4.If you try to use your pc to log in the management page,please make sure your pc is not connect to the router via Ethernet cable.

5.If you can't log in the management when the device is in AP Mode, please check the IP address arranged by the upstream router, then use this IP address to log in.

Is the power adapter and POE box waterproof?

No,they are not waterproof,please keep them away from the water.

Wi-Fi doesn't reach the advertised distance,what should I do?

When there is no obstacle between the wavlink device and the target area,the 5g signal could reach about 300m and the 2.4g signal could reach about 100m for clients like phone.

Please try to avoid the obstacle.

The actual distance may depend on the environment.

Please be free to contact our support team if you meet any problem.

Should I install the Ground wire?

Yes,it is necessary to install the ground wire to avoid Static electricity and lightning strikes.

What should I do if I could not get internet from wavlink device after configuration?

If you configure the wavlink device as repeater mode.

1.Please make sure you should enter the correct wifi password of the host router when you try to repeat the wifi signal.

2.Please make sure the dhcp of the host router is enabled.

3.Make sure the mac filter of the host router is not enabled.(Otherwise the wavlink device might be blocked)

If you configure the wavlink device as AP mode.

1.Please make sure the dhcp of the host router is enabled.

2.Make sure the mac filter of the host router is not enabled.(Otherwise the wavlink device might be blocked)

3.Please connect the pc to the modem/host router via Ethernet cable directly and check if you could get internet.(To rule out the problem of the modem/router)

Can this device form a mesh network with my routers of other brands?

No,this device could only form mesh system with the specific wavlink device which support everything mesh technology.For the devices which support everything technology,please refer to the link below:

Everything Mesh Setup Guide | WAVLINK User Guide

Could this device work with starlink router?

Yes,our device could support ap/router/repeater mode.

In repeater mode,it could build a wireless connection with the starlink router.

In router/ap mode,you could connect the wavlink device to the starlink router via Ethernet cable.

How to reset the device?

Please press the reset button for 6s when the device is powered on.

Could this device repeat the wifi signal with captive portal?

No the device could not repeat the signal with captive portal.

Could this device be powered by a solar battery?

Yes,it could be powered by the solar battery,just make sure you could provide DC48-54v for the device.

I want to use wavlink device to build a wireless connection with my host router,is Ethernet cable necessary?

In repeater mode,the wavlink device could build a wireless connection with the host router,you need not connect the wavlink device to host router via Ethernet cable.

However you still need to connect the wavlink device to the poe box via Ethernet cable.It could only be powered by poe adapter/switch.

Can I use this device to the POE switch?

If the POE switch could support 802.3 at/af protocol,our device should work well with it.

Can I control the client which connect to the wavlink device?

Please configure the wavlink device as ap mode and connect it to the host router via Ethernet cable.Then you could control all the clients which connect to the wavlink device in the management page of the host router.

Top

Overview
Q&A