+1 8889730883
( UTC -5 ) Mon - Fri 9AM - 6PM
English
  1. Home
  2. Wireless Networking
  3. WIFI 5
  4. WL-WN570HA2-GW
WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point
  • WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point 1
  • WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point 2
  • WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point 3
  • WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point 4
  • WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point 5
  • WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point 6

WL-WN570HA2-GW - AC1200 Dual Band Outdoor Access Point

Greenwood-5-1200

Model: WL-WN570HA2-GW

*AC1200 Dual-Band Range Extender: With Wi-Fi 5 technology at its core, the WAVLINK outdoor AP keeps you connected in stride with speeds reaching up to 1200Mbps. Ideal for smooth HD streaming, online gaming, and bandwidth-heavy activities. Whether you're in the yard, by the pool, or in a parking lot, relish dependable Wi-Fi 5 connectivity wherever you are.
*Power Over Ethernet: Integrated Power over Ethernet (PoE) enables power and network data connections to be consolidated into a single RJ-45 cable, allowing installation in areas without power outlets. It is equipped with passive PoE and also supports active PoE. You can use and connect your own active switch.
*IP67 Rated Weatherproof Case: The IP67-rated weatherproof and heat-resistant enclosure ensures continued operation in harsh outdoor environments, including extremely cold, hot or constantly humid climates. It can withstand a wide range of humidity and temperature (-10°C to 50°C or -14°F to 122°F), and has 15KV ESD and 6KV lightning protection.
*Multiple Working Modes: It supports four working modes. The repeater mode extends the Wi-Fi coverage of an existing wireless network. Router mode creates an instant private wireless network, enabling multiple devices to share it. AP mode converts a wired network to a wireless one. AP+Repeater mode extends the range of a wireless network by using a repeater to amplify and relay the signal from an access point.
*Outdoor Access Point: Providing ultra-fast networking speed of 300Mbps over 2.4G band and 867Mbps over 5G band, the outdoor Wi-Fi repeater has a maximum coverage range of 200 meters, supports up to 32 devices. Simple settings enable wireless optimization to improve the quality and effectiveness of link transmission. (Coverage may vary based on the actual environment.)

  • Overview

  • Specifications

  • Q&A

Specifications

  • TECHNICAL SPECIFICATIONS
  • Model

    Greenwood-5-1200

  • Ports

    1 x WAN/LAN 100Mbps

  • Button

    1 x Reset(8s); Status LED: 1 x Power, 1xWAN/LAN, 1 x WiFi , 3 x Signal

  • Power Supply

    DC 54V/0.3A Power over Ethernet(Passive), DC 48V Power over Ethernet(Active)

  • Wireless Standard

    IEEE 802.11 a/b/g/n/ac

  • Frequency Band/Speed

    2.4GHz(300Mbps), 5GHz(867Mbps)

  • Antenna

    2 x 7dBi Omni Directional Antennas

  • Wireless Security

    WPA-PSK/WPA2-PSK encryption

  • Unit Size(without antennas)

    18cm x 5cm x 5cm/ 7.1in x 2in x 2in (L x W x H ); Antenna Length: 25cm/9.8in

  • Ethernet Cable Length

    100cm/39.4in

  • Power Adapter Cable Length

    120cm/47in

  • Operating Temperature

    -10°C~50°C(-14°F~122°F)

  • Storage Temperature

    -30°C~70°C(-22°F~158°F)

  • Distance

    Outdoor 200m(Change with the Actual Environment)

Q&A

What should I do if I could not log in the management page?

1.Please connect the wifi signal of wavlink device then use http://waplogin.link or http://192.168.30.1 to log in the management page.

2.Try to use different device like your phone or pc to log in the management page.

3.If you try to use your phone to log in the management page,please try to disable the mobile network.

4.If you try to use your pc to log in the management page,please make sure your pc is not connect to the router via Ethernet cable.

5.If you can't log in the management when the device is in AP Mode, please check the IP address arranged by the upstream router, then use this IP address to log in.

Is the power adapter and POE box waterproof?

No,they are not waterproof,please keep them away from the water.

Wi-Fi doesn't reach the advertised distance,what should I do?

When there is no obstacle between the wavlink device and the target area,the 5g signal could reach about 300m and the 2.4g signal could reach about 100m for clients like phone.

Please try to avoid the obstacle.

The actual distance may depend on the environment.

Please be free to contact our support team if you meet any problem.

Should I install the Ground wire?

Yes,it is necessary to install the ground wire to avoid Static electricity and lightning strikes.

What should I do if I could not get internet from wavlink device after configuration?

If you configure the wavlink device as repeater mode.

1.Please make sure you should enter the correct wifi password of the host router when you try to repeat the wifi signal.

2.Please make sure the dhcp of the host router is enabled.

3.Make sure the mac filter of the host router is not enabled.(Otherwise the wavlink device might be blocked)

 

If you configure the wavlink device as AP mode.

1.Please make sure the dhcp of the host router is enabled.

2.Make sure the mac filter of the host router is not enabled.(Otherwise the wavlink device might be blocked)

3.Please connect the pc to the modem/host router via Ethernet cable directly and check if you could get internet.(To rule out the problem of the modem/router)

Can this device form a mesh network with my routers of other brands?

No,this device could only form mesh system with the specific wavlink device which support everything mesh technology.For the devices which support everything technology,please refer to the link below:

Everything Mesh Setup Guide | WAVLINK User Guide

Could this device work with starlink router?

Yes,our device could support ap/router/repeater mode.

In repeater mode,it could build a wireless connection with the starlink router.

In router/ap mode,you could connect the wavlink device to the starlink router via Ethernet cable.

How to reset the device?

Please press the reset button for 6s when the device is powered on.

Could this device repeat the wifi signal with captive portal?

No the device could not repeat the signal with captive portal.

Could this device be powered by a solar battery?

Yes,it could be powered by the solar battery,just make sure you could provide DC48-54v for the device.

I want to use wavlink device to build a wireless connection with my host router,is Ethernet cable necessary?

In repeater mode,the wavlink device could build a wireless connection with the host router,you need not connect the wavlink device to host router via Ethernet cable.

However you still need to connect the wavlink device to the poe box via Ethernet cable.It could only be powered by poe adapter/switch.

Can I use this device to the POE switch?

If the POE switch could support 802.3 at/af protocol,our device should work well with it.

Can I control the client which connect to the wavlink device?

Please configure the wavlink device as ap mode and connect it to the host router via Ethernet cable.Then you could control all the clients which connect to the wavlink device in the management page of the host router.

Top

Get the Scoop First

Subscribe to our official website to receive exclusive first-hand news and stay up-to-date on our new product releases and promotions!